I have a question about the Buffalo transoms.
1.The transoms plans on one page shows adding 2 inches on the long side. I cannot figure out why this is needed.
3/8 Marine Plywood:
Part Edge Dimension Additional Edge
Front Transom Long 32 33 3/4
Short 15 ~ 17
Vertical Ctr 26 28 11/16
Bottom Transom Long 27 30 13/23
Short 14 1/2 ~ 16 1/2
Vertical 19 24 5/32
How do I cut these transom? What is the extra tab for? Do I cut it later?
2. What is the percent of bevel for bottom and the sides?
Bob Marlatt
rjmarlatt@gmail.com
360-870-5272